Printronix SL5000r RFID Smart Label and Thermal Printers Manuel d'utilisateur télécharger pdf (Page 259)

ETHERNET PARAMS Submenus

259

ETHERNET PARAMS Submenus

NetBIOS Protocol

• Enable (the default). The NIC will respond to the NetBIOS protocol.

• Disable. The NIC does not recognize the NetBIOS protocol.

ASCII Data Port

This option allows you to set the port number for ASCII print jobs. The data

port number needs to match your host system setting.

The range is 0 - 65535, and the factory default is 9100.

IPDS Data Port (IPDS emulation only)

This option allows you to set the port number for IPDS print jobs.

The range is 0 - 65536, and the factory default is 5001.

Keep Alive Timer

This is the time that the Keep Alive Timer will run. Keep in mind that with the

Keep Alive Timer on, the tcp connection will stay connected even after the

print job has terminated.

The range is 2-10 minutes, and the factory default is 3 minutes.

Ethernet Speed

This menu appears only if a 10/100Base-T Network Interface Card (NIC) is

installed.

The Ethernet Speed menu has five different speed modes to allow

compatibility with different systems and networks:

• Auto Select (the default). Tells the 10/100Base-T NIC to perform an auto

detection scheme and configure itself to be 10 Half Duplex, 10 Full

Duplex, 100 Half Duplex, or 100 Full Duplex.

• 10 Half Duplex. Tells the 10/100Base-T NIC to communicate at 10

Megabits per second using half duplex.

• 10 Full Duplex. Tells the 10/100Base-T NIC to communicate at 10

Megabits per second using full duplex.

• 100 Half Duplex. Tells the 10/100Base-T NIC to communicate at 100

Megabits per second using half duplex.

• 100 Full Duplex. Tells the 10/100Base-T NIC to communicate at 100

Megabits per second using full duplex.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 393 394

Pas de commentaire

Printronix SL5000r RFID Smart Label and Thermal Printers Manuel d'utilisateur Page 259