Printronix SL5000r RFID Smart Label and Thermal Printers Manuel d'utilisateur télécharger pdf (Page 216)

216

Chapter 3

Host Form Length (VGL)

Sets the printer page size.

• Enable. Sets the printer label size equal to Label Length from the host

form length command. (For more information, refer to the

IGP/VGL

Programmer’s Reference Manual

• Disable. Sets the printer label size equal to the Label Length set in the

front panel under the PRINTER CONTROL menu.

The factory default is Enable.

Host Override

Determines whether the printer accepts certain commands sent by the host,

or continues to use the current operator panel settings.

• Disable. Allows these host commands to override operator panel

settings: line length, forms length, lines per inch (LPI), characters per inch

(CPI), print quality, and text orientation. Note the information appearing on

the message display may not match the data stream setting. No values

will change upon initial selection of the Disable option.

• Enable. The operator panel settings override the host commands.

The factory default is Disable.

Host PI

• Disable. The host does not send PI signals.

• Enable. The host sends PI signals. The Data Bit 8 configuration option

must be disabled to transmit the PI line to the printer.

The factory default is Disable.

I-2/5 Selection

This option is added to be compatible with a special

IGP-X00 customization. Usually, if Interleaved 2/5 bar codes have an odd

number of digits, a leading zero is inserted in front of the data. However, this

special IGP-X00 customization gives you the option of adding a space

character at the end of the bar code instead.

• Leading Zero. A leading zero is inserted in front of the data.

• Trailing Space. A space is inserted at the end of the data instead of a

leading zero.

• X2 DPD. When selected, I-2/5 bar code with a magnification X2 will use

the specially configured ratios 3:3:6:5 rather than 3:6:9:12 for

compatibility issues.

• Modulo 7 CD. The I-2/5 bar code uses a modulo 7 check digit instead of

the default modulo 10 check digit.

The factory default is Leading Zero.

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 393 394

Pas de commentaire

Printronix SL5000r RFID Smart Label and Thermal Printers Manuel d'utilisateur Page 216